nanoDLP

rob

Member

Registered: 2017-09-28

Posts: 54

Calling RAMPS reconnect from GCODE boxes

Is  there any command to trigger "Ramps Reconnect" from GCODE boxes?

Our idea is to have the following setup for strict safety regulations:
-Raspberry Pi always on;
-RAMPS control board and projector power controlled through GPIO --> 230V 5V relays

This way we can have projector and RAMPS switched off while not using, without the need for the user to do it manually.
I would like to know: is there any command to use with  [[Exec Command]] to trigger RAMPS reconnect? This way we can configure it to automatically switch everything on before printing, trigger reconnect and start all needed operations.

Thanks in advance for help!

Last edited by rob (2017-11-16 16:23:40)

Shahin

Administrator

Registered: 2016-02-17

Posts: 3,546

Re: Calling RAMPS reconnect from GCODE boxes

[[Net http://127.0.0.1/ramps/reconnect]]

rob

Member

Registered: 2017-09-28

Posts: 54

Re: Calling RAMPS reconnect from GCODE boxes

Great, thanks for the super fast response.