You are not logged in.
Pages: 1
Hello all, I have a weird one. Has anyone had a problem where nanodlp finishes the job but just quits sending layers to the printer at some point? It was working fantastic then out of the blue this, I have had 4 jobs now all different heights believe they completed but missing some amount of the tops of them. The layers stop at random and the print otherwise is perfect and there is nothing in the vat. Everything is pristine except for the print being finished. So I thought my nanodlp mem card corrupted so I bought a new SD card and rebuilt it. No change.. I then took the 4 prints and put them in CW and it finished all of the prints. So I thought my Pi was bad and put both the old and the new SD card in them with the same results.. Cant figure this one out.
Thanks
Rick
Offline
Share a new debug file. (setup page/ tools tab/debug button)
Offline
So odd behavior.. It did this for two days in a row and no I cannot get it to malfunction again.. It even finished the same previous plates that it didnt before..
Offline
Pages: 1