nanoDLP

WouldyouPrintaCar

Member

Registered: 2017-10-23

Posts: 3

Printer stopped showing up on the nanodlp dashboard

I'm using a Wanhau D7 if that matters. Everything was working a few days ago but now it won't show up when I log onto the dashboard. This is all over a local network. I tried turning it off an on again a few times and still nothing.

Any ideas on how to trouble shoot it?

Thanks for any suggestions.

bigfilsing

Member

Registered: 2016-11-20

Posts: 306

Re: Printer stopped showing up on the nanodlp dashboard

Check your router to see what IP address has been assigned to Nano DLP.  Under DHCP it may have been assigned a different IP address than your previous sessions.  Most routers will allow you to reserve a specific IP address for a device by using its IMAC number