nanoDLP

crankshaft

Member

Registered: 2017-10-12

Posts: 17

Mask - Preview Existing Mask

When going into mask generator, the page automatically generates a new mask (100% white) and it appears that it is this mask that is used when doing a preview.

If a new mask has not been generated, can you use the existing mask instead of a blank / 100% white mask which I believe is what is happening now.

I need to be able to re-test a mask and right now I can't do that without completely regenerating it again.

Also, can you add the ability to save a mask ?

Thanks

Update
=====

A few other things, it would be REALLY nice if the page loads the old mask definition and add a button to clear the values.

Last edited by crankshaft (2017-10-18 13:18:36)

Shahin

Administrator

Registered: 2016-02-17

Posts: 3,546

Re: Mask - Preview Existing Mask

If I understand what you want correctly, just click on one of measurement boxes and it should display measurement grid.
Update mask button save mask! I have renamed it to prevent confusion.

Reset button has been added to the page.