You are not logged in.
Pages: 1
Hi All
well my self build is almost there however... lol
If I go to plates and chose the print I want, then go to layers and click display layer
IT WORKS.
hooray!
BUT
when I run the print then NOTHING shows on the LCD.
Please what hae I missed.
Im running the basic setup RPI3, LCD, 1 stepper, 2 end stops...
MIke
Offline
Do it skip layers after print or it stall on the first layer?
Offline
does not seem to. it cures for 3 seconds lifts and moves on but nothing on screen
Offline
Could you share debug file? (setup page/tools tab/debug button)
Offline
i think that should be it.
Offline
Please, take another debug file after issue. (couple of layer skips)
Offline
Ok, just after startup
nanodlp.debug.-312566051.zip
and about 10 layers in, no layer skips that i could tell just nothing showing on screen
nanodlp.debug.-1094497023.zip
Offline
Has that given any clues Shahin?
Offline
It is extremely small screen. Only thing which I suspect in this stage is "Display Communication Type" option on setup page. Change it to disable, maybe display's driver does not support it.
Offline
Shahin, your a marvel, didnt realise that wasnt needed.
THANK YOU
Offline
Pages: 1