nanoDLP

Xmike

Member

Registered: 2016-03-25

Posts: 97

Image Reflection

Hi Shahin,

Me again

Maybe I just overlooked something.
Can one in nanodlp set somewhere that the layer get mirrored ?
My printer is a "bottom-up" with a 45 degrees mirror for Horizontal to Vertical projection. the layer will be mirrored there.
In "Asiga Stomp" I can mirror the model before slicing, but it would be better within nanodlp,
otherwise one can also not use the "Plate Generator".
The projector mask fits and should there not be mirrored.
If one looks at the behavior similar to Creation Workshop,
then the Layer first should mirrored and after that get processed with the Projector Mask.

Shahin

Administrator

Registered: 2016-02-17

Posts: 3,546

Re: Image Reflection

Mike,

You could get the same result with your projector (mirroring options), and for many reason in it will be better than software implementation in nanodlp.

Xmike

Member

Registered: 2016-03-25

Posts: 97

Re: Image Reflection

Shahin,

You're right,
on this way I had not thought.

Thanks