You are not logged in.
Pages: 1
Hi to all,
i'm new of dlp printer but after one year with my prusa i3 i think that it's time to made a new prokect.
so i wanto to buld m personal sla printer and i want to use raspberry pi and ipad retina display.
so befour staring i have some questione.
1) nanodlp supports retina display resolution?
2) I need to controll only z axis so i need miniaml control ( i think a little arduino with stepper motor driver ) i don'r want to use ramps and mega but arduino uno or nano wit driver. Exist any firmware compatible to made this?
3) the Surface where resin catalize, how it work? i need a specific material? what is the height from the bottom where is the image projected from the retina display?
thx to all
Offline
Have you already seen on this page?
Offline
Hi Xmike, thx for you replay.
Yes i have seen that forum, there are more topic about sla with retina display and there are more problem.
one by one i'll try to solve but befour start i need to understand
NanoDLP work with higest resolution? or support only 1920x1080?
How can i connect to sinc z axis? is there a wiki ore a guide?
Last edited by Kuspide (2016-05-03 13:59:09)
Offline
I've learned that the retina display are different on different iPad models. For example, The Retina Display on a 9.7-inch iPad has a resolution of 2048x1536, but the iPad 2's screen resolution is 1024x768. So which level of retina display resolution does Nanodlp support? Go check retina display for each iPad models here: Full List of Apple iPad Models and Generations Till 2018
Last edited by JakeTse (2018-10-29 04:56:58)
Offline
No limitation on resolution on nanodlp side but you have limits on hardware side, for rpi max resolution is 4k
Offline
Hi guys,
This thread interest me... so, keeping the discussion, is the Pi able to output a custom resolution of 2048x1536 to an ipad 3 LCD?
Thanks
Offline
Pages: 1