nanoDLP

cholubin

Member

Registered: 2017-06-19

Posts: 47

Is there a menu or function like this..

If printer go over specific temperature, Nanodlp automatically stop the machine.
Is there any setting tool or menu that I can control like above function?

bigfilsing

Member

Registered: 2016-11-20

Posts: 306

Re: Is there a menu or function like this..

In theory and based on the fact that a lot of SLA / DLP printers use FDM control boards, Configure the firmware and make a thermostat that then connects to the "filament out" sensor on the control board. Just an idea

Shahin

Administrator

Registered: 2016-02-17

Posts: 3,546

Re: Is there a menu or function like this..

You can also use stop GPIO, by sending true it will stop printer.
We can have pause GPIO too.