nanoDLP

Xmike

Member

Registered: 2016-03-25

Posts: 97

Cancel a print is not possible

If I want to cancel a print, e.g. when the printer gets stuck after a failed configuration, nanoDLP refuses to abort the print with the message that this is not possible while the printer is printing.
Even with Setup - Tools - "Force Stop" it is not possible.
I must either kill the printing process or restart Raspberry.
Hardware:
Arduino with Ramps-Board.

Shahin

Administrator

Registered: 2016-02-17

Posts: 3,546

Re: Cancel a print is not possible

Where exactly it gets stuck?

Xmike

Member

Registered: 2016-03-25

Posts: 97

Re: Cancel a print is not possible

Hello Shahin,
If an error occurs in GCode, e.g. when I make performing tests, then nanoDLP can not be canceled.
Only a reboot of Raspberry ends the state.
In the present case, I once the query [[WaitForDoneMessage]] inserted too much, and then I could not stop NanoDLP.

Last edited by Xmike (2016-04-17 13:31:29)

Shahin

Administrator

Registered: 2016-02-17

Posts: 3,546

Re: Cancel a print is not possible

Nice video.
I will push fix with new beta version.