You are not logged in.
Pages: 1
I wanted to scale down a previously printed plate....
I cloned the original resin profile
At the bottom of the cloned profile I changed the X/Y Model size modifier and the Z Model Modifier to 50 (precent)
I then resliced...
This did result in the number of Z layers being cut down and also either X or Y being scaled (not sure which) but not both.
I can see this in the first layer which is supposed to be a circle but with the scaling it becomes very elliptical. Hence my guess that only one
of X or Y was changed.
Am I doing this wrong? Do I need to put something in the Override X/Y resolution (which would seem to scale my 'pixel' size which would not be
correct as that doesn't really change.
Thanks
Darren
Offline
If you are using Y resolution on setup page. The resolution modifier on resin profile page only effects X resolution. I think it will be better idea if it could effects both x y but still not sure.
Offline
Yes I am using the Y on the setup page....I really didn't want to, preferring to use just the X/Y but everything I edit the page it puts 0.0000 in as the default for Y instead of leaving it blank then the other changes I make are rejected until I delete the 0.00s so that the page can be accepted and sometimes I forget and my other changes do not take place....so I think either the page should accept 0.000 as a null entry or better do not put the 0.000 in if there is no value in Y.
Offline
You are right, will take care of the issue soon.
Working on pretty big feature for nanodlp on my free time. Will fix smaller issues after that.
Offline
Pages: 1