nanoDLP

Andre267

Member

Registered: 2017-04-21

Posts: 9

Self Made DLP Printer

Hi there,

i currently design my own Printer from Scratch in Fusion 360 and plan to use NanoDLP.
It will look like this (just bigger): https://www.youtube.com/watch?v=mBYeK8bk64A

But i don't know what Firmware i should use (that will be supported by NanoDLP.
Currently i plan to use a Rasberry Pi 2 B + Adruino Meda + Ramps 1.4 and the Display + Driver Board (will be connected to the Rasberry HDMI Port).

Any Ideas?

Shahin

Administrator

Registered: 2016-02-17

Posts: 3,546

Re: Self Made DLP Printer

Patched Marlin firmware is the most common firmware being used with nanodlp.