nanoDLP

atlemo

Member

Registered: 2017-04-05

Posts: 10

Flipped plate?

The width and height should be flipped here, and the plate preview should be rotated 90 degrees, right?

Shahin

Administrator

Registered: 2016-02-17

Posts: 3,546

Re: Flipped plate?

If you flip the width and height, image will be horizontal. Your display driver default mode could be vertical, so you need to rotate image on config.txt too.

atlemo

Member

Registered: 2017-04-05

Posts: 10

Re: Flipped plate?

hm, I'm unable to save the change, it just says "Value must be greater than or equal to 0", but I can't see where it's supposed to go. Which number it's talking about.
My Y-resolutions is 0,000000, though. I don't think I should change that?

Shahin

Administrator

Registered: 2016-02-17

Posts: 3,546

Re: Flipped plate?

No you do not have to change it.
Probably older config file being used on new build, so some required fields do not have value.

I have removed required property from some inputs on setup page. Please, try the beta version and let me know if the issue still persists,

atlemo

Member

Registered: 2017-04-05

Posts: 10

Re: Flipped plate?

Ok, thanks. I manually bypassed it now by just remoing the "min-value" from the markup.
In the middle of a print, but I'll try the latest beta once it's finished.

atlemo

Member

Registered: 2017-04-05

Posts: 10

Re: Flipped plate?

Oh, btw; is it not possible to create new plates while printing? Right now it's just generating missing images.

Shahin

Administrator

Registered: 2016-02-17

Posts: 3,546

Re: Flipped plate?

You can add plate during the print but slicing will start when printer get idle.