nanoDLP

R3dfuel

Member

Registered: 2021-12-13

Posts: 4

Phrozen Transform: LCD not turningn on

Hello!

After following the Phrozen Transform group in getting the NanoDLP to setup on my Transform,

I followed all the directions per the instructions on the PDF and everything. I am able to log in thru the Wifi and see the printer and all settings accordingly.
My issue now is my LCD doesn't seem to turn on even when I go into the Display Calibration settings. The UV Light array turns on but not the Mono LCD I have.

Here are the specs for the Mono LCD: 13.3 inch 3840x2160  Mono LCD got it from Alibaba "13.3inch 4k 3840*2160 monochrome LCD screen for 3d sla printer"

I'm assuming I need to have some settings to let the NanoDLP know of my LCD? I have done some test prints and everything runs according to the settings for the printer but no LCD turns on. Any help will be much appreciated. Thank you.

Shahin

Administrator

Registered: 2016-02-17

Posts: 3,546

Re: Phrozen Transform: LCD not turningn on

you need to correct config.txt file with correct parameters for your mono lcd

R3dfuel

Member

Registered: 2021-12-13

Posts: 4

Re: Phrozen Transform: LCD not turningn on

you need to correct config.txt file with correct parameters for your mono lcd

I have tried and gotten inside config.txt but it’s empty. I have also looked at some similar samples from others but I don’t exactly know what to put inside config.txt.

Could you help me or point me in the right direction please.

Shahin

Administrator

Registered: 2016-02-17

Posts: 3,546

Re: Phrozen Transform: LCD not turningn on

Checkout link below and nanodlp online documentation

https://docs.google.com/spreadsheets/d/ … edit#gid=0

R3dfuel

Member

Registered: 2021-12-13

Posts: 4

Re: Phrozen Transform: LCD not turningn on

I will take a look. Thank you!