You are not logged in.
I have installed nanodlp in phrozen shuffles 2015, the movements with hmi display are correct, test inLCD is correct too, but when i goes to print not move, allways is in the same position, what is doing bad?
i use all components only upgrade HMI from 3.5 to 4.3 inches
nanodlp last stable version
Last edited by mariopi (2021-10-19 10:42:41)
Offline
Probably firmware is not synchronizing. Is the manual movement works?
Offline
yes it works, manual move, homing etc, only not move in layers
Offline
OK, it is surely synchronization issue
https://docs.nanodlp.com/manual/code/#synchronization
Offline
solved, was a problem with Z min sensor, not move axis when print and when program layer movements in resin parameters this are inverted
Offline