nanoDLP

andron_h

Member

Registered: 2020-04-16

Posts: 9

endstop at the top

Hello!
I bought a nanodlp board to replace direct control. My printer has an endstop at the top. What do I need to change in the settings so that the printer is parked at the top?

andron_h

Member

Registered: 2020-04-16

Posts: 9

Re: endstop at the top

I think I need to change the parameter Z_home_dir to 1, but in stock firmware need change (NanoDLP on и Pin 8 отключена (для UV))
Where change it?

Shahin

Administrator

Registered: 2016-02-17

Posts: 3,546

Re: endstop at the top

https://github.com/nanodlp/Marlin/tree/nanodlp