You are not logged in.
Pages: 1
https://docs.nanodlp.com/guide/controll … -end-limit
there we have grid of 3x4. If we use jumpers only horizontally it is a grid of 2x4. If you look the description of pins, the labeling of the pins don't make any sense. As a default, the controller board comes with the jumpers set as follow: gnd-gnd, and gnd-vcc_io. WTF? And the 2 jumpers would refer to 2 different mcrostepping settings, 8 and 64.
I have been working a lot with these things albeit not being an electronics engineer but to me this looks very confusing.
How can I drop the amount of REAL MOVEMENT into 2,5 of the movement happening now? I want to get my 5mm pitch ball screw moving the right amounts. Honestly my marriage and family start to brake up with my anger out of this mess.
(non-existing)God help us
-PropellerHat
Last edited by PropellerHat (2021-07-03 20:24:50)
Offline
Pages: 1