You are not logged in.
Pages: 1
I tried to use asiga stomp to make slices and noticed the the finished print is inverted.
I did try the mirror the model in stomp but the slices came up corrupted.
would it be possible to mirror the image when the plate is generated?
or is there any other way to get the print correct. worked just fine when using Creation Workshop.
Offline
You can mirror image image by changing config.txt on raspberry pi.
Offline
My knowledge in these thing is close to zero. I was happy I even managed to install nanodlp on the raspberry.
What config file should I change and from what to what?
Offline
Check out display_rotate section.
https://www.raspberrypi.org/documentati … fig-txt.md
Offline
@GoffyOne
- open your model in stomp and mirror it
- save it as a new file
- open the mirrored file and slice it.
When you open the mirrored model stomp can slice it. At least it worked for me.
Offline
Check out display_rotate section.
https://www.raspberrypi.org/documentati … fig-txt.md
so I added the DISPLAY_ROTATE=1
and it indeed rotates the display, unfortunately it is still only 1440 wide instead of being 2560.
Offline
@GoffyOne
- open your model in stomp and mirror it
- save it as a new file
- open the mirrored file and slice it.
When you open the mirrored model stomp can slice it. At least it worked for me.
yes, that worked, I didn´t think that by saving the stl first will make stomp slice it without errors as it does when slicing after mirroring it.
Offline
Pages: 1