nanoDLP

bigfilsing

Member

Registered: 2016-11-20

Posts: 306

Communication to ramps

Hi guys
Apologies if this has been covered before Ive been readign for 2 hours and havent found a similar issue.

So i have a RPI3 and a ramps 1.4 board with just a single stepper driver on the Z axis with a stock 1.8 deg 1.25amp stepper motor,
Ive tested the ramps with the standard test sketch as well as stock Marlin and used pronterface to control.All works fine

SO then i connected to the RPI3
Couldnt get it to work so used SSH to check the /dev path and corrected that in my path set up . That cleared the serial connection issue.
But now im getting 'Serial communication Error short write" and have no idea what this means.

All help appreciated Thanks

Shahin

Administrator

Registered: 2016-02-17

Posts: 3,546

Re: Communication to ramps

Are you sure the serial port address is correct?

bigfilsing

Member

Registered: 2016-11-20

Posts: 306

Re: Communication to ramps

Are you sure the serial port address is correct?

Thanks for the reply
Is that different to the path ?  im not very conversant with Linux / Raspi

Shahin

Administrator

Registered: 2016-02-17

Posts: 3,546

Re: Communication to ramps

No it is same. I guess it is wrong address or it has an issue.

bigfilsing

Member

Registered: 2016-11-20

Posts: 306

Re: Communication to ramps

Thanks again for the reply
CLearly i need to do some more research on this . Ill report back when i know more

Cheers

bigfilsing

Member

Registered: 2016-11-20

Posts: 306

Re: Communication to ramps

No it is same. I guess it is wrong address or it has an issue.

Well i reinstalled everything from scratch and its working now . Thanks for your patience and support.

Looking back i think i may have typed the letter cap "O" instead of the number "0" in /dev/ttyUSB0