nanoDLP

RubberFistFight

Member

Registered: 2021-01-21

Posts: 19

Direct control - issues with Z axis after starting print.

Z height isn't increasing during the print. It just keeps returning to the same point. What the hell is going on? None of this makes any goddamn sense.

Last edited by RubberFistFight (2021-01-23 03:36:49)

Shahin

Administrator

Registered: 2016-02-17

Posts: 3,546

Re: Direct control - issues with Z axis after starting print.

Share a debug file.

RubberFistFight

Member

Registered: 2021-01-21

Posts: 19

Re: Direct control - issues with Z axis after starting print.

Share a debug file.

Nah. I scrapped it altogether and went back to my old control board. It's clear that direct control doesn't work properly and your preferred solution seems to be "buy my overpriced controller instead".