You are not logged in.
Hello,
I am using NanoDLP on my custom mUVe 3D printer since 2016. This is the best software for 3D printer in my opinion. Recently I bought a Sonic Mini 4K and I am curious is it possible to convert this toy to use NanoDLP? I am sure the mechanical part ( stepper driver, homing switches) would not be a problem, but the monochrome display will. The display is 6.1 inch with 3840 x 2160 resolution. What do you think?
Offline
I have seen people running nanodlp on chitu board but it will require time to configure it correctly (ARM32 build)
If you are willing to change the board itself, nanodlp is very easy to integrate only issue is to come up with correct config.txt for your display on raspberry.
Offline
Hi Shahin, thanks for the answer. If I replace the Chitu board with RPi, how can I connect the mono LCD with RPi?
Offline
You need driver if it is embedded on chitu.
Offline