You are not logged in.
Pages: 1
Hi all,
need help.
I have downloaded the NanoDLP, flashed SD card, fired up Pi4
I have Nextion LCD and V3.0 shield.
The LCD doesn't work and the Z motor would not move.
It appears that there is no output on the GPIO's at all.
Tried to setup LCD to any available guide that I found, changed the pins and etc - nothing.
Tried to enable Z motor and measured the voltage on the enable pin - nothing.
Any ideas?
Tried on Pi3 as well.
any help would be much appreaciated
Offline
Pages: 1