You are not logged in.
Hello, I setup my pi by following the instruction, and in the step of configuring static IP address (in both file interfaces and file dhcpcd.conf), i changed it to 192.168.0.105 (also gateway to 192.168.0.1) which is matching the pi's IP address. However i cannot access http://192.168.0.105 after reboot. Any problem is there?
Thx
Offline
Jeff,
Could you ping your device?
ping 192.168.0.105
Take a look at the following post
http://www.nanodlp.com/forum/viewtopic.php?id=17
Offline
unfortunately NO.
Offline
by the way, i'm using wireless card, is there a potential problem?
Offline
Jeff,
It is a network misconfiguration.
Current version of nanodlp supports upnp and online dashboard.
If the rpi has access to internet, it will be shown here http://www.nanodlp.com/dashboard.
If not check windows network area, maybe you could find correct address this way.
Offline
during setup, if you press "y" on the network config question, some file gets overwritten which screws up the wireless config. you have to connect using cable and reconfigure wireless. after that you're good to go since the program can update itself without reinstall.
Offline
I end it up with changing subnet to 192.168.1.0.
This is a great software, thanks for your great contribution.
Offline