nanoDLP

sandong

Member

Registered: 2019-12-17

Posts: 5

Raspberry 4

I saw your mention about installation of NanoDLP to Raspberry $.
As you mentioned, after installing Raspbian Lite on RPi4, I ran "(wget ...) ...; sudo ./setup.sh".
However, the screen of the RPi4 is turned off and the HDMI screen does not work. And no ssh connection.
I'm wondering what to say "yes" in the setup.sh question.

Shahin

Administrator

Registered: 2016-02-17

Posts: 3,546

Re: Raspberry 4

HDMI being used for projection so black hdmi output means correct installation. You need to use network connection to control it.

sandong

Member

Registered: 2019-12-17

Posts: 5

Re: Raspberry 4

"HDMI" understood as you explained.
But no ssh, no telnet, no ping.
This is what happens when I run setup.sh.

Last edited by sandong (2019-12-23 08:15:13)