nanoDLP

4lathe

Member

Registered: 2019-10-02

Posts: 42

High Memory Usage Message

I got these messages in the log and did not know how to interpret them. This is Nanodlp 2418 running on a Phrozen Shuffle XL. The .stl hollowed, drain holes( no infill) and support done in Formware but sliced on the Shuffle was 110MB. It is a 2 inch high by 1 inch square semi detailed model.
1 what does the whole high memory message mean?
2 I saw something in an earlier post about Unknown Command that seemed inconclusive. I have changed nothing on this Shuffle XL other than using macdarren’s method of updating  Nanodlp. I have not added or edited the gcode that was there in any way. So why would it be reporting Unknown Command?
Thx in advance for any help.

Shahin

Administrator

Registered: 2016-02-17

Posts: 3,546

Re: High Memory Usage Message

1. when nanodlp detects high memory usage on pi, it keep trying lower memory usage.
2. it is response from RAMPS, so you are sending something from nanodlp code boxes which RAMPS could not recognize and so it skips

4lathe

Member

Registered: 2019-10-02

Posts: 42

Re: High Memory Usage Message

Trying to figure out what the Unknown Command. I have not changed any of the stock Phrozen gcode.

4lathe

Member

Registered: 2019-10-02

Posts: 42

Re: High Memory Usage Message

That obviously is unreadable, but as I said its all stock.