You are not logged in.
Pages: 1
I just bought a HieHa SQ3 (10.1") LCD printer and am trying to figure out workflow. The test print that was sent with the printer works fine however when I try to slice a model and print a "plate" it doesn't come out right despite using the exact same default settings. Does anyone have any suggestions right off the bat? I've been going back and forth with the company and they offer a single suggestion a night (China) and after 6 days I'm growing a little weary of it.
So I just started a print that is supposed to be 1.25" thick. It is on layer 190/242 and is about .3" high.. I know when it retracts there will be a layer of hardened resin maybe 1/16" (2mm) thick either stuck to the FEP or to the build plate.
I look forward to figuring all this out, running the printer and reciprocating on these forums!
Thank You beforehand for your help!
Josh
Offline
Pages: 1