You are not logged in.
Pages: 1
Hi
Its been a while since i did any resin printing and upon returning i noticed that the calibration plate options in NanoDLP have changed.
I must have a brain block or something as i cant seem to figure out how to configure it to get decent usable results.
It would be great if somebody could explain their process or share their set up.
I've searched here on the forum but didnt really find anything that offered a straight forward approach.
All of my resins to date have cure times in the 10 to 13 second range ( i have a YHD101 / KLD1260 with i believe a 20 watt UV LED)
I have ordered some "fast" resin and would like to use the calibration plate to figure out the best cure times for the new resin.
All help appreciated .
Regards
Phil
Offline
Pages: 1