You are not logged in.
Pages: 1
Hi Shahin,
Would this work to remove any peel and moves between layers? Basically do a dual exposure on each layer? Only on Odd.
M650 D{([[LayerNumber]]=ODD)*2+3} S{4-(([[LayerNumber]]<30)*3)}
M651
G4 P1000
G1 Z[[LayerPosition]]
[[WaitForDoneMessage]]
[[PositionSet [[LayerPosition]]]]
Offline
M650 D{([[LayerNumber]]%2==1)*2+3} S{4-(([[LayerNumber]]<30)*3)}
M651
G4 P1000
G1 Z[[LayerPosition]]
[[WaitForDoneMessage]]
[[PositionSet [[LayerPosition]]]]
Offline
Thanks Shahin!
If I want to add 30 microns to eliminate hysterisis from motion (it's the same in up or down z)
M650 D{([[LayerNumber]]<30)*2+3} S{4-(([[LayerNumber]]<30)*3)}
M651
G4 P1000
G1 Z0.03
G1 Z[[LayerPosition]]
[[WaitForDoneMessage]]
[[PositionSet [[LayerPosition]]]]
Just in the before each layer correct?
Offline
And if I want to remove peel completely just take out the M650 (configure peel) and M651 (call peel move) correct? New segment would read:
G1 Z2.0 S{4-(([[LayerNumber]]<30)*3)}; level lift with dynamic speed
G4 P1000; if needed pause at top of lift (will this over-ride the wait on lift - is it still required? The peel command was removed)
G1 Z-2.0; move back to original position
G1 Z0.03; remove up hysteresis
G1 Z[[LayerPosition]]; move to next layer position
[[WaitForDoneMessage]]
[[PositionSet [[LayerPosition]]]]
Offline
Noob gcode question:
Is there an easy way to remove the dual motor peel that muve does? Can I just take out the M651 comment? The above (where I just did the G1 Zxx move) did not seem to work. The print hangs at this command.
Thanks all!
Offline
You can try official marlin firmware which supports nanodlp. You should be able to remove M codes.
https://reprap.org/wiki/G-code#M651:_execute_peel_move
Offline
Pages: 1