You are not logged in.
- Topics: Active | Unanswered
#1 2019-06-15 17:14:41
- RodrigoDeNadai
- Member
- From: Brasil
- Registered: 2018-12-04
- Posts: 21
Decrease Mask Intensity - Calibration Plate
Hi Shahin,
Is it possible to include "Decrease Mask Intensity" in the calibration plate section?
It will be usefull to define the cure time with lower mask intensity.
Thank you
Offline
#2 2019-06-16 04:16:58
- Shahin
- Administrator
- Registered: 2016-02-17
- Posts: 3,546
Re: Decrease Mask Intensity - Calibration Plate
Added to the development backlog.
Offline
#3 2019-06-17 14:26:14
- RodrigoDeNadai
- Member
- From: Brasil
- Registered: 2018-12-04
- Posts: 21
Re: Decrease Mask Intensity - Calibration Plate
Thank you again Shahin
Offline