nanoDLP

yaoalen

Member

Registered: 2019-02-10

Posts: 2

I don't know what that means

In the (3D Printer Board) setup ---(Start of Print Gcode)，and the (Override Machine Level Settings)----(Override Start of Print GCode)，i want to change the speed  of the platform's initial descent to a certain position in changing the speed，How do i write the G-CODE and where is it written?

Shahin

Administrator

Registered: 2016-02-17

Posts: 3,546

Re: I don't know what that means

It is not nanodlp specific, read RAMPS firmware specific gcode standard, usually F parameter indicate speed.