nanoDLP

Sacha

Member

From: Belgrade- Serbia

Registered: 2016-08-26

Posts: 19

Website

Estimated time . . .

Dear All, maybe only I have this as problem! It is about Estimated time to finish print. Is it that hard to calculated real time necessary to print the part. If you have few Burnin layer, and few hundreds normal layer to print, how come you can mis hour or two in calculation and give estimated time with this big error in calculation. What generate this problem and can you fix this that we can realy plan our prints ? Thanks in advance !

Shahin

Administrator

Registered: 2016-02-17

Posts: 3,546

Re: Estimated time . . .

If you print plate using a profile, for the next plates with the same profile you should get pretty accurate time estimate.