How to change the center of the screen

moudy242 · 2018-04-11 23:03:43

I would like the image projected on the screen to be located more towards the edge of the screen not at its center
Can someone help me with specific details. Thank you

Shahin · 2018-04-12 05:28:14

Place pieces wherever you want in 3d editor and do not use center plate when adding plates.

moudy242 · 2018-04-12 05:44:13

Thanks but this is not what I mean. I need it to be automatic. Where any 3d model loaded to be printed goes automatically to the location even if it is centered in the CAD file.

Shahin · 2018-04-12 05:54:27

Current it does not supported. I am not sure if it 100% achievable with config.txt, but you can try push it to corner using config.txt.

moudy242 · 2018-04-12 06:02:36

What lines control the position?

Doug · 2018-04-13 18:53:54

Overscan, but I can't put it to work

nanoDLP

#1 2018-04-11 23:03:43

How to change the center of the screen

#2 2018-04-12 05:28:14

Re: How to change the center of the screen

#3 2018-04-12 05:44:13

Re: How to change the center of the screen

#4 2018-04-12 05:54:27

Re: How to change the center of the screen

#5 2018-04-12 06:02:36

Re: How to change the center of the screen

#6 2018-04-13 18:53:54

Re: How to change the center of the screen

Board footer