nanoDLP

Xmike

Member

Registered: 2016-03-25

Posts: 97

Choose the origin when adding a Plate

Hello Shahin,

It would be good if one could choose the origin for the centering of the layers, while adding a Plate.
I use Meshmixer for preparing the print job, where the default origin is in the middle of the platform.
It is possible to change the origin in Meshmixer, but that does not work somehow.
If I want to keep the arrangement in NanoDLP, I currently load the file in ASIGA Stomp and make there an offset of the origin to the corner,
before I load it in NanoDlp without "Auto Center".
It would be good if I could choose the origin between "Auto Center" , "Bottom Center" and "Bottom Corner" when adding a Plate,
then an origin offset is not anymore necessary.

Last edited by Xmike (2016-05-28 20:49:01)

Shahin

Administrator

Registered: 2016-02-17

Posts: 3,546

Re: Choose the origin when adding a Plate

Hi Mike,

Good suggestion, thanks.

Shahin

Administrator

Registered: 2016-02-17

Posts: 3,546

Re: Choose the origin when adding a Plate

It is available on the beta version.