nanoDLP

nnnn2013

Member

Registered: 2017-11-21

Posts: 13

Platform Information - Move - Floor and Top movements

hi,
Direct control
Settings:
Endstop Switch - Top Limit - Disabled
Endstop Switch - Bottom Limit - Physical 18
Enable GPIO State - Low

On Z Axis control page when i hit Top 1 mm, the "Current" value on the left goes down.
For example, if Current is 0, after hitting "Top" it is 0.
If i hit Floor, the "current" value goes up.
What i am doing wrong, or that's correct values ?

Thanks

Doug

Member

Registered: 2017-08-11

Posts: 100

Re: Platform Information - Move - Floor and Top movements

With you use a top home, you have to enable it
are you using [[PositionSet [[CurrentPosition]]]] for every movement?

nnnn2013

Member

Registered: 2017-11-21

Posts: 13

Re: Platform Information - Move - Floor and Top movements

Doug, thanks for reply.

are you using [[PositionSet [[CurrentPosition]]]] for every movement?

I am doing Direct Control. No RAMPS and Arduino.
Only Raspberry pi 3 and A4988.
That's why i thought "[[PositionSet [[CurrentPosition]]]]" doesnt make any sense and "3D Printer Board - Shield connection" is Disabled.
"Bootup Gcode,  Start of Print Gcode, Resume Print Gcode, Print Stop Gcode, Shutter Open Gcode, Shutter Close Gcode, Manual Movement Gcode Template" they are all empty.

With you use a top home, you have to enable it

Where to enable ?